APPLY HERE
Req. ID: 122728
Job Description
As a Global Facilities Technology Team (GFTT) Mechanical Systems Engineer at
Micron Technology- Inc.- you will be responsible to provide high quality
engineering services and specifications for the planning- design-
construction- operation- and maintenance of your discipline specific
Facilities systems in support of semiconductor manufacturing across the Micron
Global Manufacturing Network. You will participate in capacity and scenario
planning across the network and evaluate impact of changes. In this role- you
will support the Facilities Teams and Manufacturing sites across the network
as a Subject Matter Expert through all phases of design- construction-
installation- start-up- operations and maintenance and will ensur
environmental- safety- regulatory- and code compliance. Responsibilities an
Tasks
Design and Plan Systems and Buildings
Provide system designs for safe operations and maintenance
Develop- review- and maintain the equipment and component specifications and standards for the corporation.
Ensure material compatibility
Ensure designs comply with all applicable standards- codes- and regulations
Reviewing of the capacity planning databases (with Base Build capacities- POC assignments- and actual field conditions) across the network and validating utilization and diversity factor assumptions.
Review and advise sites on periodic system status presentations (system capacity- actual load- and projected loads based on all approved scenarios- key system accomplishments- and challenges/issues)
Assist sites with the evaluate system and distribution capacity impacts based on scenario changes as requested.
Reviewing and advising on scope for facilities infrastructure additions or modifications
Provide Project Support
Provide Micron specifications and standards to Design Firms and reviewing detailed designs and specifications for the installation of new facilities infrastructure
Provide support for cost and schedule estimates and justification for approval
Provide supervision and coordination of consultant resources required
Ensure appropriate communication with local facilities- Design- Construction- Procurement and manufacturing stakeholders as required to deliver project objectives and deliverables.
Be responsible for the timely review of design packages and providing documented comments and feedback as necessary.
Work with appropriate personnel to address problems or make corrections
Ensure that scope meets requestor needs
Ensure change management procedures are followed.
Monitor progress and provide engineering and design support during construction as required per project if necessary.
Provide Technical Support- Leadership- and Expertise
Provide consultation and support to Operations and Maintenance and Manufacturing as Technical Discipline Subject Matter Expert
Analyze system designs to identify improvements that will result in better performance- efficiency gains- reduced maintenance- and cost savings
Support sites with problem analysis using standard tools and methodologies as requested.
Provide Technical leadership and support to Procurement group on vendor qualifications- Vendor Selection and negotiations as needed.
Conduct risk and failure mode and effects analysis
Eliminate single points of failure and mitigate risk
Benchmark within and external to Micron sites on engineering and design BKMs of Facilities buildings and systems
Own and maintain of Corporate Facility of Record (FOR) Standards for your discipline.
Maintain leading edge applicable domain knowledge (chemical theory- instrumentation control theory- high purity principles- etc.)
Maintain equipment support knowledge (reaction modes/mechanisms- hazard protocol- leak detection- etc.)
Job Requirements:
Bachelor`s Degree in Mechanical Engineering required- Master`s Degree desired.
Minimum 10-year experience in Semiconductor MUA- Recirc Air- Process Cooling Water- Process Exhaust- CDA- Pvac etc. Systems
Ability to prioritize and schedule workload and work on multiple tasks concurrently
Good organizational skills and Service attitude
Excellent communication skills and good team working skills- English Required
Self-motivated worker
Familiarity with semiconductor manufacturing and facilities systems
Ability to travel internationally up to 75% of the time
Location: F10N 1- North Coast Drive- Singapore 757432
AECOM Engineer/ Senior Engineer (Mechanical) in Singapore- Singapore